
This two-car garage in Universal City took us 6 hours to complete. The bare concrete was diamond ground, then finished in three layers: polyaspartic base coat, Outback flake to full coverage, and a clear polyaspartic seal.

When we arrived, the slab had dark staining spread across both bays and was paler and worn near the door. Diamond grinding took off the surface layer and left the concrete open and rough, which is what the polyaspartic base needs to bond properly.
Once the base was down, we broadcast Outback flakes into it, covering the whole floor until the gray concrete was hidden. The clear polyaspartic seal coat went on last. At the front, the coating stops at the trench drain across the garage door opening, so rain and wash water still run straight into it.

You will find Outback under code FB-517 in our epoxy color chart. Its tan and brown chips sit well against the wood paneling in this garage, and the mixed pattern makes tire marks and dust less obvious between cleanings.
The polyaspartic top coat has a gloss finish, so spills can be wiped up rather than left to soak into bare concrete. We used the same flake on a La Cañada Flintridge garage, and more of our garage work is on the garage floor epoxy page.
Send us the rough size of the garage, a photo of the concrete as it is now, and whether there is a drain, a step or an old coating to work around. With that we can tell you what the prep involves before anyone comes out.
Free garage quotes are available by phone on (818) 359-3932, or through the estimate form on this page.
GET A FREE Estimate
Please give us a call or fill in our contact form to receive more information about our flooring services.
For instant reply you can call us, text us, or connect with us on social media.